Components
COMPONENTS
ILLUSTRATION
|
*1 | LOWER STEERING COLUMN COVER |
*2 | MULTIPLEX TILT AND TELESCOPIC ECU |
Installation
INSTALLATION
PROCEDURE
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
(a) Engage the 2 claws to install the multiplex tilt and telescopic ECU.
 |
Install in this direction |
(b) Connect the connector.
2. INSTALL LOWER STEERING COLUMN COVER
Click here
3. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
Click here
Removal
REMOVAL
PROCEDURE
1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS
Click here 
2. REMOVE LOWER STEERING COLUMN COVER
Click here
3. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
(a) Disconnect the connector.
|
*a | Protective Tape |
 |
Remove in this direction |
(b) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the multiplex tilt and telescopic ECU.
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Rear Speed Sensor RH Circuit Output (C1415,C1416)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. HINT: The output voltage values shown below are for when the vehicle wire harnesses are connected to the skid con ...
