Components
COMPONENTS
ILLUSTRATION
|
*1 | COWL SIDE TRIM SUB-ASSEMBLY LH |
*2 | FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
|
*3 | FRONT DOOR SCUFF PLATE LH |
*4 | HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
|
*5 | INSTRUMENT SIDE PANEL LH |
*6 | NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
|
*7 | NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
*8 | STEERING HEATER SWITCH |
Inspection
INSPECTION
PROCEDURE
1. INSPECT STEERING HEATER SWITCH
| (a) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
5 (IG) - 2 (B) | Steering heater switch is pushed |
Below 1 Ω | |
5 (IG) - 2 (B) | Steering heater switch is not pushed |
10 kΩ or higher | If the result is not as specified, replace the steering heater switch. |
 |
|
*a | Component without harness connected
(Steering Heater Switch) | | |
(b) Indicator Inspection
(1) Apply battery voltage to the steering heater switch and check that the indicator illuminates.
OK:
|
Condition | Specified Condition |
|
Battery positive (+) → Terminal 2 (B) Battery negative (-) → Terminal 4 (E) |
Illuminates |
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING HEATER SWITCH
(a) Engage the 2 claws to install the steering heater switch.
 |
Install in this direction |
2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here 
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL INSTRUMENT SIDE PANEL LH
Click here
6. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
8. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here 
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
HINT:
Disconnect the front door opening trim weatherstrip LH to the extent that allows the removal of the instrument side panel LH.
4. REMOVE INSTRUMENT SIDE PANEL LH
Click here
5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
7. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here
8. REMOVE STEERING HEATER SWITCH
(a) Disengage the 2 claws to remove the steering heater switch.
 |
Remove in this direction |
